ab line

Hi We've just had a second hand patchwork system to go with our first 24m spreader and I think I'm confusing myself! Spreading to 24m, we need to travel at 12m widths. So, is your working width in patchwork 12 or 24? I think I've managed to work everything out - measuring, AB etc from online...

I have all my fields saved in the ez 500, and works great but i wonder if you need to complete the headland before you can see the AB line. I mean, this year its muddy in some places in the field and i wont be able to reach the saved Headland line. So can i skip over that part of headland and...

Have bought a 4m one pass with tank on front. First time doing our own. What do I need to know / would be usefull hints? One of my first questions is how many headland runs to do? We are on 28 m tramlines and have had some contractors do 5 and some do 6 dependent on the field. Are people just...

Hoping the techies on here can help Since last year we have had a new to us Amazone ZA-TS spinner, wich was eventaully fully set up with GPS switch, sectional control etc. No autosteer. Now I may be thick, (probably) but what do people do for guidance with this? i.e. setting up and following AB...

Our patchwork has gone buggered. Dealer says about £1200 for a new one. Can one be made or bought for less? Fertiliser spreading and a little drilling will be its jobs.

I have a tractor with a Starfire 3000 antenna and since a couple of months ago i started having problems with the GPS signal, it keeps dropping sf1 and going to egnos, wich i can't use for steering. The antenna has been on this tractor since new, we don't take it off except over winter. Also, it...

2016 7720 steer ready with an aftermarket Agleader Incommand on RTK. The tractor is sitting approx 25cmm off the line always to the right. The problem was intermittent. I had this before and the problem was with the tractor rather than the Agleader system. Problem sorted out by dealer at that...

We are having issues with our T7.315. New last year and FMX installed by dealer and GPS supplier (well known national firm) at local tractor dealership. It is on RTK with a local Trimble base station. We run three FMX units in CNH tractors and the other two are working fine. Last autumn and...

The centre of the stripper header I am about to use is off centre to the centre of the combine as per the attached diagram. As I am new to using offset in auto steer ,how much offset do I need to put in to allow for the stripper header bouts to match up.The figures in brackets are allowing for...

Is there an other way to make a fully functional field boundary then using the headland mode? I would like to make them by using field mark option, while driving autopilot on exsisting ab lines, which I have already made in my fields… I tried that today, but when I finish boundary, it is saved...

I'm trying to get to grips with the features on a Trimble XCN-1050 on New Holland with autosteer. I've recorded the field boundary and now want to mark 24m tramlines using autosteer. Is it possible to set the guidance and autosteer to 12 m from the boundary and then infill with 24 m tramlines...

A picture thread of AgOpenGPS (AOG) installations and in field work, to hopefully encourage others as to what's possible. I know on TFF we have AOG users who are steering as manual lightbar, foam wheel motor, 3D printed cogs, 'Baraki' hydraulic valve, OEM hydraulic valves and over CanBus! So...

We run a couple of 18m tedders and as the crop dries it can become very difficult seeing where to drive , low sun, pollen or just final pass before baling . I thought a simple light guidance would really help . I have been offered 2x Trimble EZ 250 units at not expensive money but then...

What are my options for retro fitting a steering guidance system on an older tractor ('04 Fendt 818)? No I don't want to buy a newer tractor. What should I be looking out for and what possible issues to be aware of? Looking for a complete easy to operate system with a decent sized screen for...

I'm just going to New farm using 6 metre drill and 36 metre tramlines they don't tramline headlands. Bit stupid but when do I put my tramlines in only been used to a little combi with no tramlines big step and don't want to look a plonker with tramlines everywhere they do middle first any help...

Is anyone using the new all in one PBC's? Just about got my original PCBv2 system fully operational, and my mind moves to the next tractor - but there have been so many jumps in the technology since then!

In my quest for an alternative source of RTK rather than selling my kidney, liver and both arms to JD for their rtk I have happened across the Canadian firm Agra GPS, Is anyone using their CRG receiver on a JD for rtk? Priced at 4000 USD (extra for modem if needed to run mobile rather than...

Since its 1st March tomorrow, thought I'd start the next year's worth of sugar beet fun and games 🤦‍♂️ @Breckland Boy have you started....or finished!! drilling yet?

After recording a boundary with the CNH system, I can create a field AB line parallel to any section of the boundary line on the screen, without driving along that section again. I can create a new AB line while in autosteer - for example along a straight section of a curved line. I can get...

Evening all, Considering dropping in a water pipe to save on a lot of earaches. Need to take it about 1km. Guessing a trencher is the best option, assume pipe will needed to be sanded in etc. I can work out the cost of the pipe, fittings and sand but not sure on labour to unravel the thing and...