Steevo
Member
- Location
- Gloucestershire
See I was spot on. Clive would be thinking on how to spent it all.
I once saw a system at HR Bourne’s that was very good.
So one conveyer down the side of shed ( ie long ways ) then one under it ( short ways ) on rails. The short conveyor has an open bottom so the grain drops in, till it rises to the conveyor. Then moves across the building till it’s full. Then the conveyer moves forward either on a sensor or manual on a hand held.
The result is a shed loaded from above with no compaction, perfectly level to the base of the cross conveyor.
Would be top job in your set up if you used above floor round ducting. But not for pedestals.
At Bourns they had below floor vents.
It could work well for you.
All good til the conveyor breaks down.....