Got my kuhn 30.1 quantron out the shed last week, checked it out and all fine, actuators working fine so good to go.
Went to put it on an hr ago for the morning and the right hand actuator is now saying fault in the metering system. when you put it in manual mode the left actuator will open and close from 0 to 580 as normal and the right will open the same, (from shut to fully open when i look into the bottom of the spinner) and shut again but the scale on the quantron in the cab says that when its fully open its 580 (correct), but when its shut it only drops to 180 instead of 0. I presume this is whats making it recognise a fault. Its an 08 machine< any ideas???
Looks like im not going spinning in the morning then.... bloody things!
Went to put it on an hr ago for the morning and the right hand actuator is now saying fault in the metering system. when you put it in manual mode the left actuator will open and close from 0 to 580 as normal and the right will open the same, (from shut to fully open when i look into the bottom of the spinner) and shut again but the scale on the quantron in the cab says that when its fully open its 580 (correct), but when its shut it only drops to 180 instead of 0. I presume this is whats making it recognise a fault. Its an 08 machine< any ideas???
Looks like im not going spinning in the morning then.... bloody things!