- Location
- North West Wales
Yes Cyl no1 will be at front. I just use rule of nine when doing tappets on them, did one yesterday.
rule of 9?Yes Cyl no1 will be at front. I just use rule of nine when doing tappets on them, did one yesterday.
rule of 9?
BTW, I was very surprised to find head bolts all needed 1-2 turns after just say, 6-8 engine hours after new rebuild. Previously, I torque to 75 pounds, but this time I torqued to 80 pounds (user manual states 75-80). At this point I set tappets to 20 thou. I will check head bolts again in a dozen hours. Tractor starts first turn of the key after a few seconds of heat, sounds good too, with even idling.