Nh intelliview iv experts

Chae1

Member
Location
Aberdeenshire
When I setup a new headland it automatically sets it up as half the implements width. This is fine when spreading fert etc. It puts me 18m from boundary @36m.

Its annoying though when drilling as always 2m out on 4m drill. Does anyone know how to cancel half width default?
 

Jimbo

Member
Location
The kingdom
When I setup a new headland it automatically sets it up as half the implements width. This is fine when spreading fert etc. It puts me 18m from boundary @36m.

Its annoying though when drilling as always 2m out on 4m drill. Does anyone know how to cancel half width default?
I found similar when having a play setting up boundary’s . But I’m a novice just now . There’s a Young scotish chap on YouTube setting up boundary’s and headland lines that might help .
 

Chae1

Member
Location
Aberdeenshire
No I don’t but the guy sounds pretty dour ?
That you then ?
Yeah that sounds a bit like me!

I've only got 4 video's on YouTube. I kept forgetting how to record boundaries so filmed it so I remembered next time.

One thing I learned was everytime you go in with a new implement you create a new field from boundary with that implement width. I wasn't doing this when going in with drill and that wasn't helping. I created the boundarys with tractor so only 3m wide, drill 4m.

When fert spreading I've been creating a new field with fert spreader width and been working fine.
 

e3120

Member
Mixed Farmer
Location
Northumberland
When I setup a new headland it automatically sets it up as half the implements width. This is fine when spreading fert etc. It puts me 18m from boundary @36m.

Its annoying though when drilling as always 2m out on 4m drill. Does anyone know how to cancel half width default?
There's a setting on a Trimble, which the nh is based on. Can choose full or half width.

I don't understand what's wrong with what it's doing with your 4m drill - are you recording the boundary after doing a half width or something?
 

Colliedog

Member
Location
Dorset
I don’t know the correct way to do it but what I have been doing is recording an outer boundary which I rename field boundary. Then I record another boundary at half the drill width which I rename drilling boundary. Both are saved in the memory. I then use drilling boundary for drilling and field boundary for everything else.
 
Last edited:

Could a ‘Meat Tax’ be on the cards in the UK?

  • 113
  • 0
Written by Richard Halleron from Agriland

The latest machination coming from the so-called ‘opinion formers’, who seem to have the ear of government advisors in London, is the introduction of a ‘Meat Tax’ at consumer level.

This approach, it is argued, would have the combined impact of reducing meat consumption levels (I can really see the health benefits coming through now), while also helping to reduce the overall carbon footprint of production agriculture.

What absolute drivel! In my opinion, none of this makes sense at any level. This is a scurrilous and unfounded attack on livestock farming in this part of the world.

Yet, it has to be taken seriously. I make this point because economists at Rothamsted Research have already crunched the numbers where the introduction of a ‘UK...
Top