- Location
- SW, MN
Now that I have it in the tractor, I was going through a few more menu's and have a few more questions.
This will be used for planting with a 12 row 30 in. twin row semi mounted monosem planter.
What should the look ahead ft. be? currently its 32.8' I forgot what screen that was on.
2. Planter over lap? positive number? Negative?
3. rear off set with semi mounted planter? I didn't see a setting for semi mounted equipment.
4. End of Row. 1st. setting 164' 2nd. 82' look ahead 32.8' is this ok for what I'm doing?
5. After updating, there were several boundary's (I didn't save any, none were mine anyway) So I deleted them all except the active one.
6. Boundary offset. If the fence line is on my left, would I have a negative off set?
Then would I set my offset at 1/2 the planter width plus say 15"? I won't be driving boundary's before planting. I'll do it on my first pass. Maybe flag where to drive.
7. For planting what steering mode do I use? 99.9 % of my acres are straight lines. . So do I use Adaptive curve? or something else? A+B
8. Another question is that none of the tractors (units) were removed when I updated the software. I had put mine in, and there were 2 other's there when I got it. Maybe it is setup that way and that is why there were so many boundary's left ?
This will be used for planting with a 12 row 30 in. twin row semi mounted monosem planter.
What should the look ahead ft. be? currently its 32.8' I forgot what screen that was on.
2. Planter over lap? positive number? Negative?
3. rear off set with semi mounted planter? I didn't see a setting for semi mounted equipment.
4. End of Row. 1st. setting 164' 2nd. 82' look ahead 32.8' is this ok for what I'm doing?
5. After updating, there were several boundary's (I didn't save any, none were mine anyway) So I deleted them all except the active one.
6. Boundary offset. If the fence line is on my left, would I have a negative off set?
Then would I set my offset at 1/2 the planter width plus say 15"? I won't be driving boundary's before planting. I'll do it on my first pass. Maybe flag where to drive.
7. For planting what steering mode do I use? 99.9 % of my acres are straight lines. . So do I use Adaptive curve? or something else? A+B
8. Another question is that none of the tractors (units) were removed when I updated the software. I had put mine in, and there were 2 other's there when I got it. Maybe it is setup that way and that is why there were so many boundary's left ?