glasshouse
Member
- Location
- lothians
Match this spline please
- Thread starter glasshouse
- Start date
- Location
- Lorette Manitoba
By the colour it’s claas si your off to a claas proctologist. The nut looks added on. Or find a good machine shop with a broach to make you one but they’ll want the shaft out to measure and match too. costly too that route
glasshouse
Member
- Location
- lothians
I welded the nut on
Not wanting to spend much, someone must have a match lying under the bench or in the nettles
- Location
- Lorette Manitoba
Probable but without more info on number of splines. Machine it’s off and what the spline attaches too it’s hard to say if anyone has one. If it’s not a high speed and power application I’d be tempted to change it to a lesser diameter in a lathe and cut a keyway in it.
- Location
- Lincolnshire
Cut the external bit that fits on it length ways, once with a thin cutting disc, weld a couple of lugs with holes on next to the lengthwise cut, then put a bolt and nut through the lugs to clamp the external part tightly round the splined shaft? Depends what the external bit is like though. If it’s cast or elaborate, you can’t do it.
- Location
- Lorette Manitoba
Your a smart cookie drwazzock.
glasshouse
Member
- Location
- lothians
I havent got that bit
Beames
Member
- Location
- South wales
What’s it off?
glasshouse
Member
- Location
- lothians
Claas baler 250
Beames
Member
- Location
- South wales
If it had been a Rollant 46 might of been able to help as have a scrap one.
glasshouse
Member
- Location
- lothians
Its not a baler part, i want to add it to thr baler to ease unblocking
- Location
- our house, Norn Iron
That where the big handle goes on, which you don't have?
The handle was soft if I mind right, thing I wrung it in the end.
glasshouse
Member
- Location
- lothians
Its a piece of sh!t
Exfarmer
Member
- Location
- Bury St Edmunds
I would guess it is a 20 or 21 spline pto shaft for a 100 rpm pto.
Just do a count as that is important
Just do a count as that is important
glasshouse
Member
- Location
- lothians
Its too big, 50mm across
glasshouse
Member
- Location
- lothians
The nut is rounded
I think i will cut the nut off and weld on a 540 spline as the big splines seem far from common
Do you have an unblocking lever for jd?
- Location
- our house, Norn Iron
That would be my opinion on the 250 but that doesn't help you much.
Was a farmer had a combine with no reverse unblocking on it, he put a engine ring gear on it then used the starter motor from the same engine when he wanted to unblock it.
- Location
- Owaka, New Zealand
Could you weld a large socket on it, and just keep a big breaker-bar with you as a handle? I could be way off 
but inch-drive is inch-drive anywhere
but inch-drive is inch-drive anywhere