Hi all we have a Jcb 520 2002 with a perkins 1004 - 4T engine in it.
It'll start and run fine until warm (around 5 minutes) then just cuts out dead, and won't turn over until its cooled off. When its tight it can be turned over with a bar on the flywheel and there is a definite tight spot when...
Hi All Got a tm310, the boom only extends about a meter but no further, comes back in fine.
You can hear the Hydraulics cutting out when it stops, so it's not deadening etc. Any pointers? Thanks
Hi all, having trouble with an mlt 627 2012, mainly when the machine gets warmed up the brakes bind on, they bind on more when turning,
We've stripped the front axle down and can't see anything major wrong, the discs are in good order and the handbrake levers are free.
We are hoping it's just...
Hi all, got a 2012 MLT 627 TURBO, when trying to boom out the boom only moves out around 1 ft at a time before stopping, then you have to let go of the roller switch and re-press to get it to go another foot etc. etc.
The boom pulls in fine no problems at all, and if you lower the boom whilst...
Hi Steve I'm not sure on the heat sensor but some machines go off the coolant temp sensor usually on the cylinder head of the engine. I could be wrong though, thanks!!
Hi All we have a cat th220B which has lost its boom (joystick functions) red exclamation light flashing on the dash. It did this a couple months back and we bypassed the hydro/joystick cut off switch in the rear right hand corner. It worked for a while but has since stopped again,
Does anyone...
Hi Martin I'm not fully sure but fairly positive that you have to take at least 1 boom section out to do the pipes, if you can get boom right back in you can pull put the first telescope ram from the backend
Hi Martin not yet, so far we think the solenoids, joystick etc. Seem to be ok, going to have another go Monday. Have you done much to your machine? Thanks
Hi all we currently have a manitou mt1840 in. Telescope boom won't go out, if I swap plugs on solenoids it goes out and won't come in BUT when the plugs are put right it still doesn't come in. Also when the boom out switch is worked the joystick disable light comes on.
Stripped joystick all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.