Ball hitches for tractors

[Tarw Coch]

I’m looking at a second hand piece of machinery that has the weld on spoon type hitch, how much would a ball hitch cost to replace a pick up hitch hook?
With a mixed fleet I’ve got both dromone and saauerman hitches on tractors

 

[Fendt516profi]

£700-£1000ish

 

[Punch]

The ball is the expensive bit. We got a couple for about £500 a few years ago. Ours is Dromone to fit JCB & Deere, transformed baling.
I reckon £650 each now

 

[d williams]

I’m looking at a second hand piece of machinery that has the weld on spoon type hitch, how much would a ball hitch cost to replace a pick up hitch hook?
With a mixed fleet I’ve got both dromone and saauerman hitches on tractors

Depends on the tractor/hitch make not as bad as you would think for some models

 

[sjt01]

The ball is the expensive bit. We got a couple for about £500 a few years ago. Ours is Dromone to fit JCB & Deere, transformed baling.
I reckon £650 each now

Once used, there is no turning back! I would like a conversion for a JCB telehandler hitch, but have not yet found one so the bale trailer remains on ring and hook. Everything else is ball and spoon.

 

[graham mc]

if you find one make sure you post it on here where you did as were in the same boat

 

[ollie989898]

When you look at how soft JD hooks are it's almost like they are making the decision for you! At least ball + spoon can be greased properly and it stays relatively clean.

 

[Punch]

It’s ride quality and secure. Swivel ring hitches on trailers were good but every time I went to hook on they we’re twisted vertical .

 

[ollie989898]

Once used, there is no turning back! I would like a conversion for a JCB telehandler hitch, but have not yet found one so the bale trailer remains on ring and hook. Everything else is ball and spoon.

There must be a way of sorting a telehandler hitch to make it compatible with ball and spoon?

 

[farmerm]

Don't you just bolt one of these onto a draw bar or am I missing something

 

[sjt01]

Don't you just bolt one of these onto a draw bar or am I missing something
View attachment 1172181

No, this - 80 mm not 50mm or 2" - the 2" shown above became obsolete about 50 years ago.

 

[farmerm]

No, this - 80 mm not 50mm or 2" - the 2" shown above became obsolete about 50 years ago.
View attachment 1172183

So its a bigger spoon that a typical trailer or caravan... every day's a school day. Most of my kit has been obsolete about 50 years, I am still on Euro3 loader brackets

 

[David.]

So is it just that little top jaw stopping the spoon lifting off?

 

[sjt01]

So is it just that little top jaw stopping the spoon lifting off?

No, when you pick it up, the top jaw is locked against the fixed part of the pick up hitch.