We always found it ended up spilling over one side. Shelbourne apparently doesn't do it @Ducati899Anyone have a tip/trick to stop sawdust type bedding from bridging in an AG dispenser?
Driving me coco
Also, use the thread for any other tip/trick request and solution if you want
We always found it ended up spilling over one side. Shelbourne apparently doesn't do it @Ducati899
Is the bottom slide opened right up? AG here and don’t get anything bridgingStarts distributing ok but suddenly stops pushing out the sawdust as it has bridged above the auger.
Chuffing nuisance
Is the bottom slide opened right up? AG here and don’t get anything bridging
We use sand and have welded some 3/4 inch bar onto the auger long enough to still clear as it turns about 8 in total. This seems to keep sticky sand moving betterYeah .. we’ve even removed it completely
Product we have only just switched to from paper called “Fibre” from NW Resources
Fibre - N W Resources Ltd
nwresources.co.uk
Only way to get it to run seems to be to fill AG only 1/3 full but means at least 3 refills per shed
Maybe the name is a little bit of a giveawayYeah .. we’ve even removed it completely
Product we have only just switched to from paper called “Fibre” from NW Resources
Fibre - N W Resources Ltd
nwresources.co.uk
Only way to get it to run seems to be to fill AG only 1/3 full but means at least 3 refills per shed
I find if you ram the bedder full it trys to bridge, better to scoop it up lightly so it stays fluffy in the bucketYeah .. we’ve even removed it completely
Product we have only just switched to from paper called “Fibre” from NW Resources
Fibre - N W Resources Ltd
nwresources.co.uk
Only way to get it to run seems to be to fill AG only 1/3 full but means at least 3 refills per shed
That seemed the obvious answer, i didn’t even bother saying it, but perhaps they haven’t tried it!Rattle the tip lever after each row
Rattle the tip lever after each row
That seemed the obvious answer, i didn’t even bother saying it, but perhaps they haven’t tried it!
Your joking?That’s fine but ultimately it damages the headstock.
Your joking?
Your man on fb hit the ramp that fast in the 420, I don't think rattling the bucket will hurt too much!
Ah it’s on a telehandler