loader

  1. kfpben

    Too fat to farm?

    I have quite a few youngsters help me at various times of year. Vet students, 15 year old work experience kids, ag college students, the odd NEET from the county council. Most are ok, some are very good, some are muppets. However the thread that runs between nearly all the youngsters that are...
  2. J

    DB 990 getting hot, but radiator is cold?

    Hello all Having some overheating problems with my db 990. After about 15mins of work it overheats and it vents hot coolant out of the top of the radiator. But if I then touch the radiator it is all cold. I have had the thermostat out and there was some nasty black fatty stuff on it, so I took...
  3. Agriland RSS

    John Deere upgrades 5M series with power and tech

    Written by Justin Roberts from Agriland John Deere is moving digital technology firmly into the everyday tractor driving experience with what were once bolt-on additions now becoming fully embedded into the tractors’ controls. The latest John Deere 5M tractors are now not only available with...
  4. M

    HELP ALLIED LOADER

    I’m looking for the quick attach headstock for the allied loader the same is below can anyone help
  5. M

    Headstock

    I’m looking for a quick attach headstock of a allied loader got another tractor and looking a head stock for it
  6. Farm Classifieds

    TA003428 2002 VALTRA 900 4WD TRACTOR & MAILLEUX MX80 LOADER

    TA003428 2002 VALTRA 900 4WD TRACTOR & MAILLEUX MX80 LOADER Advert added by: Chandlers (Farm Equipment) Ltd Machinery Details Category: Tractors Farm Tractors Price: £14750 Condition: Used Description Valtra 900 4WD Tractor,30Kph,Manual transmission,90HP. 2 Spools,MAILLEUX...
  7. TelesnaAg

    Straining hinge joint mesh in tight places?

    I have a few runs all on flat ground where i only have 16ft gap to strain hinge joint, 300m runs. Thinking of using endless train and park tractor on angle so can get to draw bar or linkage. Any other ideas for this style of work, i don't have two fence strainers to go top n bottom etc. Ant...
  8. J.T.Agri

    Looking For Work All work considered (Shropshire/Cheshire) Further if needed

    Hi All. My name is Jordan Taylor, 29, Based near Market Drayton. I am self-employed with a wide range of experience looking for some good contacts for work throughout the year. I have my PA1, Loader, counterbalance forklift, MIG Welding and drone certificates with plans to gain First Aid and...
  9. Farm Classifieds

    TE001446 2021 MASSEY FERGUSON 6718S EFD6 4WD TRACTOR & MF FL4124 LOADER

    TE001446 2021 MASSEY FERGUSON 6718S EFD6 4WD TRACTOR & MF FL4124 LOADER Advert added by: Chandlers (Farm Equipment) Ltd Machinery Details Category: Tractors Farm Tractors Price: £56950 Condition: Used Description Massey Ferguson 6718SEFD6 4WD Efficient Spec. Tractor,50Kph...
  10. D

    Smallholding Digger Insurance

    Looking for tips on company's offering insurance for a farm digger (early 90's backhoe loader) that won't cost the earth! Currently with Adrian Flux but this years premium has tripled o_O
  11. M

    Knutsford to droitwich

    Anyone travelling back down the m6/m5 with a low loader with room for a kuhn bale wrapper. Pick up cw8 2 area Drop off hanbury or somewhere just off the of junction 5 of m5 (wychbold) Ideally sometime next week?
  12. J

    Deutz-Fahr 5090G bouncing problem on the road

    The 5090G, which he uses for light work, bounces a lot on the road. There is no suspension. The tires are Mitas. The front tire is 380/85/24 and the rear tires are 420/85/34. AC85. My tire shop said that the air pressure should be 30psi and he set them all to 30. I use the tractor for light work...
  13. W

    3 x heston bale grab

    Which bale grab for handling three heston bales 8x4x4 in size. Ideally I need to flip them over in the field so strings are outwards. This would be to load into store in a shed that goes from 4 high on the outside to 6 high in the middle. Currently using a spike with a backframe that handles 2...
  14. M

    Is this normal

    We purchased a late 2008 Manitou 627t last August. Its doing all that is asked of it. Previous owner had the spool block replaced about a year ago, which is a common fault on these. Can anyone here tell me if its normal for the engine to be put under load whilst lowering the boom. It really...
  15. Grassman

    Wet the new normal

    If the wet weather we have experienced for the last nine months was to be the "normal" I think I would have to pack in. It's just too miserable and hard work! Hopefully it's a one off season.
  16. hoyboy

    Eamon McVeigh Predator trailers

    Anyone else delt with this guy? February 2022 I Placed an order for complete new running gear for a tri axle low loader. Axles, suspension, wheels etc. £7500 worth of parts. Some stuff wasn't in stock but I said there was no rush on it but now been 2 years and still nothing! I've asked for my...
  17. W

    Driving a tractor on the road. tax!

    I’ve just purchased an international tractor and need to move it about 5 miles from where it is to my place. It’s got a v5 and obviously I’ll temp insure it for the journey, question is does it have to be taxed? It’s never going to be used on the road once it’s here. Thanks.
  18. S

    N101 valtra wont go back into gear after clutch depressed.

    Has anyone experienced problems with pressing the clutch , changing gear and the tractors stays in neutral after releasing the clutch?
  19. Elis_Anwyl

    What hydraulic system is in forage harvesters?

    i'm looking to start o conversion project of a self propelled forage harvester to a loading shovel is there hydraulic pump and resevouir in self propelled ? lookin to install a tractor loader on the front, ive only seen 1 video of a guy in the usa doing it (the pics) but he made one out of a...
  20. B

    Ripped off by HRN Tractors / Agritrac Exports Ltd (Stuart Barclay) - Aberdeenshire

    Hello I'm about to commence a county court claim against this outfit, who sold me a tractor which was significantly mis-described. Does anyone else have any similar experiences with them? Long story short, I enquired about a 2013 MF5410 early November 2023. I decided against progressing...
Top