- Location
- South Lanarkshire
Doing a service what's best to get crud oil out of bed Run with some diesel in it?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
CheersIf it's bad I start with diesel run up for a few seconds then 2 or 3 fils with hydraulic oil run for a bit longer
Not sure about that. Check your handbook.80/90
Hi I have a 1355 mower that wants oil changing in bed .I just put a couple of tyres under one end of the bed, let it down and take the end cap off. Won't be much left in after an overnight.
85-140 is the correct stuff.
Hi I have a 1355 mower that wants oil changing in bed .
I have the gasket for end .I understand you run it up and drain sloping to end .
Where do you fill ?is it the plug on top ?
I think this one is corroded can't find anything that fits it . Could tack weld key in to get undone?Heat might help!thanks
When you say bung with magnet is that the one on top side of bed where you put oil in ,which mine has corroded.thanksI ended up buying a new bung and cap screws for the end plate as they were burred over as well. If you heat the bong (typo reminded me of good times) the magnet will fall off the end most likely but we fished it out ok and replaced the bung. The bung only barely gets nipped up now.
Reckon if you put the tyre under the other end of the bed you could fill it through the end plate. ... off memory it's only a litre or so.
When you say bung with magnet is that the one on top side of bed where you put oil in ,which mine has corroded.thanks
Magnet should be on drain bung, top ones should not have magnet
It's 1.6 litres in a 55 and 2 litres in a 65 no more or you will cause overheating because you will get hyd gear pump effect,always drain warm and leave it for a while if you can2.7 litres in a 55, 3 litres in a 60/65 iirc?